SCRAPERITE HOLDERS

Tradesman Dwarf, SRT168, and W410

The holder is a performance component, not just an accessory. Scraperite holders are engineered for dual-blade compatibility, corner access, stronger leverage, and reduced hand fatigue in repeated professional use.

Handling Method

Repeatable performance and safety

Use with logo side up and maintain approximately 25-30 degrees attack angle. Flip or replace blades as edge wear increases. This maintains cleaner lift, lower rework, and better consistency across repetitive scraping cycles.

Holder Dimensions and Fit

Choose by reach requirement and blade format

Spec	Tradesman Dwarf	Tradesman SRT168	Tradesman W410
Overall Length	63 mm	168 mm	168 mm
Width	45 mm	45 mm	100 mm
Blade Compatibility	Curved + Rectangle	Curved + Rectangle	Wide Rectangle
Primary Use	Compact daily carry	Extended reach jobs	Large surface coverage

All Tradesman holders include a blade release system and reinforced construction features.

Key Functional Features

Built for job-site efficiency

Blade Release

Patent-pending mechanism for fast flipping and replacement.

Corner Access

Trimmed geometry increases access to recessed edges and corners.

Dual Blade Capability

Single holder supports curved and rectangular blades in supported models.

Reinforced Frame

Pre-stressed curve and ribbing improve leverage and torque transfer.

Ergonomic Palm Profile

Sloped back section creates smoother hand contact and comfort.

Extended Reach

Long-handle options improve reach and power on larger tasks.

Dual-Blade Versatility in Practice

Carry less, adapt faster

Switch between curved and rectangular blades to match flat runs, corners, contours, and seal lines without changing systems. The holder and blade set work as a single controlled scraping platform.